Shane AO  

Procedure: Change from LGS mode to NGS mode

1. In saoWFSFocusTrack.tcl GUI: Uncheck WFSFocusTrack in the saoWFSFocusTrack.tcl GUI.
2. In Shane AO motor control (saomot_gui) GUI: Set WFS focus motor to -20.0 (NGS focus).
3. In fieldsteer.tcl GUI: Field steer LGS motors to on axis:
   • Uncheck Move Telescope and Auto Close Loops.
   • Check LGS; push the Back On-Axis button.
   • Check NGS; push the Back On-Axis button.
4. Exit Laser Shutdown Monitor (LSM.tcl) GUI.
5. In ShaneAO loop control (saocon_gui.tcl) GUI: Set Operation Mode to NGS.
6. In Shane AO motor control (saomot_gui) GUI: Ensure Sodium filter is out (may need to cycle Uplink).
7. In ShaneAO loop control (saocon_gui.tcl) GUI: Load in appropriate NGS saved setup, if necessary.
8. If this is the end of LGS operations for the night, perform the LGS mode shutdown, including:
   • Notify FAA and USAF of termination of LGS operations.
   • In slinelamp_fe GUI: Set Spare2 to Off.
   • Re-enable timer for slinelamp_fe outlets: modify -s slinelamp LLPTEN=on.

Change Log:

2020-11-30: First version.